When the repairs add up to more than the solution, a full repipe is the honest answer.
Most plumbing problems should be patched — a single pinhole, one bad valve, an isolated failure. Repiping is a significant project, and we don't recommend it unless the math actually points that direction.
The inflection point comes when the pipe system itself is failing rather than a single weak spot. At that point, every repair you make buys you a few months before the next one — and eventually you've spent more on patches than the repipe would have cost, with years of disruption along the way.
These are the situations where we'll be straight with you and say it's time to consider replacing the lines rather than continuing to chase failures.
We visit the home, inspect the existing pipe — what it's made of, how old it is, what condition it's in, how many fixtures are on the system. We look at access points and anything that will affect the scope. You get a written quote with the full number, including permit fees, before any work is scheduled.
Repiping requires a permit in Arizona — no exceptions. We pull it before the job starts. This isn't bureaucratic overhead; it's what ensures the work is inspected by the city and stands up when you sell the home. Any contractor who skips permits on a repipe is cutting a corner that creates a legal and financial problem for you later.
We open the wall at access points — planned, minimal, and consistent. New PEX or copper is run throughout the home: cold supply, hot supply, and to every fixture. We stage the work room by room to restore water to parts of the house as we go. Your home will be without full water service for portions of the job, but we work to minimize how long and which areas are affected.
Drywall is patched at all access points. Once the new system is fully connected, we pressure test the entire line before closing anything out. The city inspection follows — a third party confirms the work meets code. Water is fully restored after inspection passes. You end up with a system that has a documented permit history and a clean bill of health.
Flexible plastic pipe that has become the standard for residential repiping across the country. For Arizona homes specifically, PEX handles hard water better than copper — it doesn't pit or corrode in response to mineral content, and it flexes slightly with thermal expansion instead of stressing at fittings. Install is faster, fittings are fewer, and the overall cost is lower than copper for most jobs.
The standard for decades and still a legitimate choice. Copper is rigid, has a proven track record, and is preferred in some high-end applications or where local code requires it. In Arizona's hard water environment, copper lasts well when properly installed and maintained — but it is more susceptible to pinhole corrosion over time compared to PEX, and it costs more in both materials and labor. We use it when it's the right call for the job.
We do not repipe with polybutylene or CPVC in Arizona homes. Polybutylene — the gray flexible plastic common from the 1970s through mid-1990s — is known to degrade and fail unpredictably; we replace it, we don't install it. CPVC is a rigid plastic that handles chlorine better than standard PVC but becomes brittle in high-heat climates. Arizona's summer attic temperatures routinely exceed 150°F, which accelerates CPVC embrittlement and makes it a poor long-term choice for homes in the Phoenix metro.
Repiping is quote-only — there's no honest flat rate because the cost depends on the size of your home, how accessible the existing lines are, the number of fixtures, your material choice, and the permit fees for your city. The ranges below reflect typical Maricopa County jobs. Your actual quote comes after an in-person assessment.
Smaller single-story homes with straightforward access. Range reflects material choice (PEX vs. copper) and fixture count.
Most Maricopa County single-family homes fall in this range. Two-story layouts and tight wall access push toward the higher end.
Larger homes, multi-story layouts, or homes with complex plumbing configurations. Quoted individually — no useful ceiling to give here.
Not the entire project — we stage the work to restore water to sections of the house as we go. On a typical 2–4 day repipe, you'll have partial water access most days. The full system will be offline during the final tie-in and pressure testing, but that's generally measured in hours, not days.
We'll walk you through the day-by-day plan before the job starts so you can plan around it. Most families find it manageable — especially knowing that at the end, the whole system is new and done.
Yes — repiping requires a permit in Arizona. This isn't optional, and any contractor who skips it is putting you at risk. An unpermitted repipe creates problems when you sell the home (disclosure requirements, title issues) and means the work was never inspected by anyone other than the contractor who did it.
We pull the permit before the job starts and schedule the city inspection when the work is done. The permit record follows the home and protects you. Permit fees ($200–$600 depending on city) are included in your upfront quote.
For most Arizona homes: yes, and in some ways better. PEX doesn't corrode or pit in response to hard water — which is the primary reason copper fails in Maricopa County homes. It's also flexible, which reduces fittings and stress points, and it handles thermal expansion better than rigid pipe.
Copper has a proven track record and is the right choice in certain situations — near water heaters where rigid pipe is preferred, in high-end applications, or where local code specifies it. We'll tell you which makes sense for your home. For most standard repipes in the Phoenix metro, PEX is our recommendation and the industry standard.
Yes. Drywall patching at all access points is part of the job. When the new pipe is in and tested, we close up the wall openings. The patches are finished — sanded smooth and ready for paint. We don't leave you with open walls or raw drywall.
We do not paint or texture-match, since matching existing paint colors and wall texture requires the homeowner's materials and is typically handled as a separate step. Most customers paint or touch up after the repipe is done. We can tell you exactly what the patches will look like before the job starts.
Generally no — not for the repipe itself. Homeowner's insurance treats plumbing replacement as a maintenance expense, not a covered loss. The damage caused by a failed pipe (flooring, drywall, belongings) may be covered, but the pipe replacement is typically not.
There are some exceptions: if a sudden pipe failure caused significant water damage, some policies will cover access costs (cutting into walls and ceilings) even if they won't pay for the pipe itself. It's worth a call to your agent before the job. We can provide documentation of what we found to support a claim if needed.
We'll come out, assess what you actually have, and give you a straight quote — repair if it makes sense, repipe if it doesn't.
Call (480) 720-7809 Mon–Fri 7am–6pm · Sat 8am–4pm